Black T-molding 16mm

T-molding smooth black 16mm.

Must be installed on arcade cabinet with grooves provided.

Please select the length. We advise you to take a little more than necessary in case of installation error (between 5 and 10%).

-- Some tips on installation.

- For a better installation, we advise you not to install in a cool place. The plastic hardens with the cold.
- Lay your bollard on its side.
- Do not use a hammer, prefer a mallet.
- Pre-position the t-molding on the ground by going around your bollard. It tends to roll up on itself. This will prevent you from fighting with it! Save your strength for Street Fighter!
- For the end cutting (you will always have a little too much), prefer to use a pro cutter (thick), to avoid injury. A cutter can do the trick but it will be a little less clean.
- You can apply glue to some places to avoid, with time, your t-molding to come off.
- If your bollard allows you to go around with the t-molding in one go, it is better to start at the bottom of the bollard so that the junction cannot be seen.
- Make a cut in the fir tree to apply it in the concave curves.
- Remove 2 parts close together in the fir for the application in a convex curve.